DDD release notesDankDroneDownloader catalog
Whats New?
- Added support to use with DJl Goggles 2. (recording from the air unit is not currently supported)
- Added support to use with DJl FPV Remote Controller 2.
- Added support to use Canvas Mode. This function is only supported when the air unit is used with DJI Goggles 2. Refer to the Canvas Mode section of the User Manual to enable OSD and set PID parameters in Canvas Mode.
Notice:
- After updating, the air unit will not support DJI FPV Goggles V2, DJI FPV Goggles V1 and the DJI FPV remote controller. When using DJI FPV Goggles V2, DJI FPV Goggles V1 and the DJI FPV remote controller, downgrade the air unit to v01.00.06.08.
- Restart the air unit, goggles, and remote controller once the update is complete.
- If the firmware update fails, restart the device and DJI Assistant 2 (Consumer Drones Series), and try updating again.
- Update the Air Unit (Lite) when there is good ventilation. Make sure that both the goggles and remote controller are powered off before updating the Air Unit (Lite). DO NOT touch the Air Unit (Lite) during update since the temperature rises. If update fails, wait for the Air Unit (Lite) to cool down and try to update again.
- Added support to use with DJl Goggles 2. (recording from the air unit is not currently supported)
- Added support to use with DJl FPV Remote Controller 2.
- Added support to use Canvas Mode. This function is only supported when the air unit is used with DJI Goggles 2. Refer to the Canvas Mode section of the User Manual to enable OSD and set PID parameters in Canvas Mode.
Notice:
- After updating, the air unit will not support DJI FPV Goggles V2, DJI FPV Goggles V1 and the DJI FPV remote controller. When using DJI FPV Goggles V2, DJI FPV Goggles V1 and the DJI FPV remote controller, downgrade the air unit to v01.00.06.08.
- Restart the air unit, goggles, and remote controller once the update is complete.
- If the firmware update fails, restart the device and DJI Assistant 2 (Consumer Drones Series), and try updating again.
- Update the Air Unit (Lite) when there is good ventilation. Make sure that both the goggles and remote controller are powered off before updating the Air Unit (Lite). DO NOT touch the Air Unit (Lite) during update since the temperature rises. If update fails, wait for the Air Unit (Lite) to cool down and try to update again.