Официальные release notesDJI getallfile API · 2018-11-15
This firmware update resolves the rare issue of mid-flight power loss due to incorrect battery level calculations. Please run this update immediately.
What's New?
• Resolved the issue of a false high State of Charge (SOC) reading of the battery where the SOC displayed in the app is higher than the actual SOC, with additional measures to protect the aircraft.
If you have multiple batteries, please run this firmware update on all of them.
• Enhanced the performance of the external GPS module, specifically improving the built-in compass’ ability to withstand signal interference. (Please connect a GPS module to the aircraft during the firmware update)
• Resolved a rare issue where the aircraft cannot take off when two downward gimbals are connected on the M210 RTK.
• Resolved a rare issue where the aircraft shakes as the gimbal turns.
• Resolved a rare issue of abnormal time settings in Interval shooting mode during Waypoint Flight.
Notes:
• This firmware update includes protection measures to ensure flight safety, and the following may occur after the update:
a. Longer warmup time before takeoff.
b. A rare situation where RTH or landing is triggered when the battery level displayed in the app is more than the value that is required for the corresponding function.
To minimize the impact to user experience, it is strongly recommended to fully charge battery and make sure the battery temperature is 20C or higher before takeoff.
• The Zenmuse Z30 should be updated to v01.00.00.47 before using the gimbal with this firmware. Reset the gimbal parameters after the Zenmuse Z30 firmware update is complete.
• Only newer Zenmuse XT models are compatible with the Matrice 200. A replacement may be required if your XT model isn't supported. Please contact DJI Support to learn more about various XT model compatibility. The Zenmuse XT gimbal adapter and DJI Pilot app are also required when used with the Matrice 200.
• If the firmware update fails, restart the aircraft and DJI Pilot \ DJI GO 4, then try updating again.
What's New?
• Resolved the issue of a false high State of Charge (SOC) reading of the battery where the SOC displayed in the app is higher than the actual SOC, with additional measures to protect the aircraft.
If you have multiple batteries, please run this firmware update on all of them.
• Enhanced the performance of the external GPS module, specifically improving the built-in compass’ ability to withstand signal interference. (Please connect a GPS module to the aircraft during the firmware update)
• Resolved a rare issue where the aircraft cannot take off when two downward gimbals are connected on the M210 RTK.
• Resolved a rare issue where the aircraft shakes as the gimbal turns.
• Resolved a rare issue of abnormal time settings in Interval shooting mode during Waypoint Flight.
Notes:
• This firmware update includes protection measures to ensure flight safety, and the following may occur after the update:
a. Longer warmup time before takeoff.
b. A rare situation where RTH or landing is triggered when the battery level displayed in the app is more than the value that is required for the corresponding function.
To minimize the impact to user experience, it is strongly recommended to fully charge battery and make sure the battery temperature is 20C or higher before takeoff.
• The Zenmuse Z30 should be updated to v01.00.00.47 before using the gimbal with this firmware. Reset the gimbal parameters after the Zenmuse Z30 firmware update is complete.
• Only newer Zenmuse XT models are compatible with the Matrice 200. A replacement may be required if your XT model isn't supported. Please contact DJI Support to learn more about various XT model compatibility. The Zenmuse XT gimbal adapter and DJI Pilot app are also required when used with the Matrice 200.
• If the firmware update fails, restart the aircraft and DJI Pilot \ DJI GO 4, then try updating again.