DDD release notesDankDroneDownloader catalog
What’s New?
• Added 50Mbps bitrate mode, which provides better image quality. In the United States, users can enable 50Mbps bitrate mode on goggles by selecting Setting, Transmission, and then Bitrate. Audience mode is not supported in 50Mbps bitrate mode.
• Added frequency range display for each channel in 25Mbps bitrate mode, making it more convenient to select different channels when there are multiple devices around to avoid interference.
• Optimized power algorithm. Full power will automatically be enabled if the flight controller is disarmed during flight. This improves the stability of the video transmission connection and increases the probability of locating lost aircraft.
• Optimized user experience when there are multiple devices in the area.
• Fixed rare issue: when the remote controller was connected to a simulator, the aircraft vibrated vertically when the throttle stick was pushed to the maximum value.
• Fixed issue: an update failure report was incorrectly sent when using DJI Assistant 2 (DJI FPV Series) to refresh current firmware.
• Fixed rare issue: air unit automatically stop recording during flight.
Notice:
• Restart the air unit, goggles, and remote controller once the update is complete.
• Make sure that the firmware of the air unit, the goggles and the remote controller are in the same version. Check the firmware version in Setting, Device Info, and then Device Info on goggles.
• If the firmware update fails, restart the device and DJI Assistant 2 (DJI FPV Series), and try updating again.
• Update the Air Unit (Lite) when there is good ventilation. Make sure that both the goggles and remote controller are powered off before updating the Air Unit (Lite). DO NOT touch the Air Unit (Lite) during update since the temperature rises. If update fails, wait for the Air Unit (Lite) to cool down and try to update again.
• Added 50Mbps bitrate mode, which provides better image quality. In the United States, users can enable 50Mbps bitrate mode on goggles by selecting Setting, Transmission, and then Bitrate. Audience mode is not supported in 50Mbps bitrate mode.
• Added frequency range display for each channel in 25Mbps bitrate mode, making it more convenient to select different channels when there are multiple devices around to avoid interference.
• Optimized power algorithm. Full power will automatically be enabled if the flight controller is disarmed during flight. This improves the stability of the video transmission connection and increases the probability of locating lost aircraft.
• Optimized user experience when there are multiple devices in the area.
• Fixed rare issue: when the remote controller was connected to a simulator, the aircraft vibrated vertically when the throttle stick was pushed to the maximum value.
• Fixed issue: an update failure report was incorrectly sent when using DJI Assistant 2 (DJI FPV Series) to refresh current firmware.
• Fixed rare issue: air unit automatically stop recording during flight.
Notice:
• Restart the air unit, goggles, and remote controller once the update is complete.
• Make sure that the firmware of the air unit, the goggles and the remote controller are in the same version. Check the firmware version in Setting, Device Info, and then Device Info on goggles.
• If the firmware update fails, restart the device and DJI Assistant 2 (DJI FPV Series), and try updating again.
• Update the Air Unit (Lite) when there is good ventilation. Make sure that both the goggles and remote controller are powered off before updating the Air Unit (Lite). DO NOT touch the Air Unit (Lite) during update since the temperature rises. If update fails, wait for the Air Unit (Lite) to cool down and try to update again.