Официальные release notesDJI getallfile API · 2021-04-30
What’s new？
1.Added support for DJI Zenmuse L1 gimbal and camera, offering users a complete integrated solution that includes a Livox LiDAR module and a 1-inch CMOS camera sensor.
2.Added Altitude Mode to mission flight when using a PSDK 102S camera.
3.Optimized calculation method to estimate the amount of time to take photos and also the number of photos left to take, providing users with greater accuracy.
4.Fixed issue: the mission could not be uploaded if the altitude was above 5,000 m during a mission flight.
5.Fixed issue: when using the Zenmuse H20T, Sun Burn Protection was not disabled even if the Sun Burn Protection Disabled button has been pressed in the app.
Notes
1.Users who use Custom Network RTK must update the aircraft firmware to v01.00.02.14 or later. Otherwise, the aircraft will work abnormally.
2.The aircraft cannot revert to firmware version 01.00.02.11 or earlier once the firmware is updated.
3.Make sure that the aircraft, remote controller, battery, D-RTK 2 mobile station (if used), payload (if used) are updated to the latest firmware version.
4.Download the latest firmware from official website to microSD card to update the ZenmuseZ30, XT S, XT2, P1 or H20 / H20T.
5.It is required to use the DJI Pilot app built-in the remote controller, or download the app of V2.2.1.7 or later.
1.Added support for DJI Zenmuse L1 gimbal and camera, offering users a complete integrated solution that includes a Livox LiDAR module and a 1-inch CMOS camera sensor.
2.Added Altitude Mode to mission flight when using a PSDK 102S camera.
3.Optimized calculation method to estimate the amount of time to take photos and also the number of photos left to take, providing users with greater accuracy.
4.Fixed issue: the mission could not be uploaded if the altitude was above 5,000 m during a mission flight.
5.Fixed issue: when using the Zenmuse H20T, Sun Burn Protection was not disabled even if the Sun Burn Protection Disabled button has been pressed in the app.
Notes
1.Users who use Custom Network RTK must update the aircraft firmware to v01.00.02.14 or later. Otherwise, the aircraft will work abnormally.
2.The aircraft cannot revert to firmware version 01.00.02.11 or earlier once the firmware is updated.
3.Make sure that the aircraft, remote controller, battery, D-RTK 2 mobile station (if used), payload (if used) are updated to the latest firmware version.
4.Download the latest firmware from official website to microSD card to update the ZenmuseZ30, XT S, XT2, P1 or H20 / H20T.
5.It is required to use the DJI Pilot app built-in the remote controller, or download the app of V2.2.1.7 or later.